Distributor of Rhodia Silicones and Synair polyurethane products

If you have questions or requests, contact us at: 214-630-8657
or toll free at:
1-866-631-2600
jim@sunbeltmaterials.com

Synair Polyurethane
 

 

 

SYNLUBE 1711

 

Applications
Synlube 1711 formula No. 6375 is the industry "cure all" for tough release problems. It is especially suitable for polyurethanes, epoxies, and Viton® and can be used to demold solid urethane tires, epoxy patterns, air filter caps, encapsulated components, rollers, friction drive wheels, impeller blades, etc. Synlube 1711 can also be used with ABS resin, polyesters, and other thermoplastics.

Characteristics
The working temperature of Synlube 1711 is from ambient to 302° F (150° C). It has very low viscosity, good wetting action, and spreads uniformly and evenly when sparingly applied. It is stable, non-corrosive, and will not cause mold buildup.

Instructions for Use
Aerosol-Note: Always use aerosol and solvent diluted materials in a well-ventilated area.

Spray lightly and evenly on clean mold surfaces. Best results are obtained from thin films. Allow the solvent in Synlube 1711 to evaporate and the surface to air dry for approximately 10 minutes. For quicker drying times, dry the master or mold surface with warm air. Use sparingly; too much release agent tends to build up and cover some details on the master or mold surface. Wipe off excess with lint free paper. Best results are obtained from thin films.

Bulk
Note: Always use aerosol and solvent diluted materials in a well-ventilated area.

Spray using an airless spray gun. For optimum results, do not use a brush or cloth to apply Synlube 1711.

Physical Properties (Bulk)
The following table lists the properties of Synlube 1711 in bulk.

Property

Synlube 1711

Color

Colorless

Viscosity @ 77° C), CPS

<3

Specific Gravity @ 77<° C)

1.22

Weight per Gallon, lb.

9.1

Solids Content

3-6

Flash Point

None

Release Type

Non-silicone

Solvent Type

1, 1-Dichloro-1-fluroethane

Storage and Handling
Be sure to read the Material Safety Data Sheet that comes with Synlube 1711 before using. Store in a cool dry place away from heat and sunlight. Recommended storage temperature is below 100° F (37.7° C). For the bulk version, keep container tightly closed to prevent solvent evaporation. Vent containers occasionally to relieve pressure especially in warm weather. Aerosol cans should not be punctured, incinerated, or used near a source of ignition.

Viton is a registered trademark of DuPont Dow Elastomers.
The conditions for your use and application of our products, technical assistance and information (whether verbal, written or by way of production evaluations), including any suggested formulations and recommendations, are beyond our control. Therefore, it is imperative that you test our products, technical assistance and information to determine to your own satisfaction whether they are suitable for your intended uses and applications. This application-specific analysis at least must include testing to determine suitability from a technical as well as health, safety, and environmental standpoint. Synair Corporation has not necessarily done such testing. All information is given without warranty or guarantee. It is expressly understood and agreed that customer assumes and hereby expressly releases Synair from all liability, in tort, contract or otherwise, incurred in connection with the use of our products, technical assistance and information. Any statement or recommendation not contained herein is unauthorized and shall not bind Synair. Nothing herein shall be construed as a recommendation to use any product in conflict with patents covering any material or its use. No license is implied or in fact granted under the claims of any patent.
Updated April 5, 2000